Upgrade Enigma2 by USBUpgrade Enigma2 by USB

Posted on: 12-15-2011 Posted in: Enigma2, EOS image

Upgrade Enigma2 by USB

Preparation:
1.We only recommend Kingston USB stick, we don’t support USB hard disk
2.Please make sure your USB stick only have 1 partition and the file system is FAT32
3.Set default booting system to [enigma2].
Upgrade Step:
1.Make sure [C:/engima2] is exist, if not, please create this folder.
2.copy [uImage] and [e2jffs2.img] to [C:/engima2]
3.Connect USB stick to STB
4.Keep Pressing [OK] Button in Front Panel, then power on STB.
5.After 5 seconds, you will see [Forc] in LED, release [OK] button and press [Right] Button.
6.if everything OK, You will see [U LD] shining in LED
7.if upgrade success, You will see [SUCC] and STB reboot automatically
If upgrade not finishes in 5 minutes, then there must be something wrong, please check your configuration and re-try.

Upgrade Step:

1. Make sure [C:/engima2] is exist, if not, please create this folder.
2. copy [uImage] and [e2jffs2.img] to [C:/engima2]
3. Connect USB stick to STB
4. Keep Pressing [OK] Button in Front Panel, then power on STB.
5. After 5 seconds, you will see [Forc] in LED, release [OK] button and press
[Right] Button.
6. if everything OK, You will see [U LD] shining in LED
7. if upgrade success, You will see [SUCC] and STB reboot automatically
If upgrade not finishes in 5 minutes, then there must be something wrong, please
check your configuration and re-try.